Xantrex RC/GS RC7 Uživatelský manuál stáhnout pdf (Strana 43)

System Status Displays

975-0210-01-01 31

When the initiating condition (battery voltage or thermostat

signal) has occurred, the Pending Genstart message is

displayed for approximately two minutes, awaiting a change in

the condition or a manual override. If neither condition occurs,

the inverter/charger attempts to start the generator and the RC/

GS displays “Cranking Genset.”

Once the generator starts, there is a brief delay to allow the

generator to reach operating speed and for the inverter/

charger to synchronize to the generator, at which point the

screen shows that AC is again available.

Starter Cooldown and Gen Start (RC/GS Only)

If the generator does not start within 60 seconds, a two-

minute starter cooldown message is displayed after which

another attempt to start the generator occurs.

The RC/GS

will make a total of three start attempts.

1.These are maximum times. They vary according to the Genset you have selected.

Genset Status:

Cranking Genset

Genset Status:

AC Available

Genset Status:

Starter Cooldown

RC-GS_manual.book Page 31 Thursday, May 26, 2005 4:58 PM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

Žádné komentáře

Xantrex RC/GS RC7 Uživatelský manuál Strana 43